I was just thinking about cable management and I had a thought.. are there any flat style molex connectors?
Kind of hard to explain what I'm visualizing. The best example I can think of is like an old IDE cable, where your cable runs flat through the connector rather than coming in then back out.
Look at this:
Note how the middle connector just kind of clamps on over the cable? I was thinking about the same thing for molex 4pin connectors. It would make cable management a lot neater because you wouldn't have essentially two wires coming out of each pin on the connector.
Like see how on the 4-pin molex connector, there's two wires coming out for each pin:
I'm wondering if there's anything out there that mounts them flat to the connector and has a single wire running down through each connector.
here's a quick MSpaint drawing of what I mean:
http://desmond.imageshack.us/Himg827...png&res=medium
on the left is the way it's done now, and on the right is what i'm talking about.
Has anybody seen anything like that before, or should I start working on drawing up some designs? I already have an idea of how it would be possible.