Project: Call Of Duty Modern Warfare 2 !!!UPDATE!!! 26 April 2010

[billygoat333]

I just started playing with sketchup... its not that bad of a program actually. but pen and paper/colored pencils and grid paper are the way to go! haha

[slaveofconvention]

Hehe - just man up and admit to it....

Is it a bird?
Is it a plane?
No, it's CRAYOLA boy!!!

[Oneslowz28]

I did some work today on a sketchup model of the C4 time bomb water pump cover. This is just about 5 minutes of work. I will try to do some more on it tomorrow.

[Oneslowz28]

I got some sanding done today on the thin rails and a few other parts of the frame. Had to quit due to hand cramps. (early signs of carpel tunnel?) What ever they coat the inside of these cases with is super easy to remove with 320 grit paper. I hope I can have everything ready for paint by this weekend but that might be stretching it.

I am still trying to figure Kerkythea so I can make my water pump cover render look realistic. The decision has been made to create a custom display for it using an arduino and LCD.

[x88x]

Had to quit due to hand cramps. (early signs of carpel tunnel?)

Probably not. Carpal tunnel is in..well, the carpal tunnel, where the nerves and ligaments enter the hand. ..oh, and it hurts like a b****.

[Drum Thumper]

I got some sanding done today on the thin rails and a few other parts of the frame. Had to quit due to hand cramps. (early signs of carpel tunnel?)

Lay off the fireman drills?

[Oneslowz28]

There will be an update this weekend I think. Depends on some stuff getting delivered.

[Oneslowz28]

Hears a quick teaser. And yes the box is FULL!

[x88x]

Heheh, congrats! Let's see what the real bitspower sent you.

[Oneslowz28]

Ok I guess I can share some photos. I would like to thank Bitspower for sponsoring this build. I will get a logo and link up later today.

Bitspower hooked me up with:

22	Bitspower Premium G1/4" Black Sparkle High Flow 3/8" (1/2" OD) Compression Fitting*
4	Bitspower Black Sparkle "T" Fitting - 180 Degree
2	Bitspower G 1/4" Black Sparkle 45 Degree IG 1/4" Adapter
2	Bitspower G 1/4" Black Sparkle 90 Degree IG 1/4" Adapter*
2	Bitspower G 1/4" Black Sparkle Temperature Sensor Stop Fitting*
3	Bitspower Crystal "Stop" Fitting G1/4" with O-Ring & 5mm LED Holder*
2	Bitspower BP-BSWP-C25 Black Sparkle G1/4" Fitting Spacer*
4	Bitspower G1/4" Stop Fitting with O-ring - Black Matte Finish*

Purchased from x88x

2	Bitspower Case Top Water Fill/ Through Hole Fitting Set - Shiny Silver Finish*
4	Bitspower G1/4" Stop Fitting with O-ring*
4	Bitspower Premium G1/4" Fitting Spacer*
2	Bitspower Dual G1/4" High Flow Fitting - Male to Male Thread
2	Bitspower Multi-Transfer Base (Coupler) - Set of 2*
2	Bitspower Premium G1/4" "Stubby" High Flow 3/8" Fitting*

Bitspower was kind enough to send me 22 Black Sparkle 3/8" Compression fittings.

Here is a pic with all of my Bitspower bling. Some of these were purchased from our own x88x.